Once you enter your battery type and charge rate, the unit automatically charges your battery to the optimum level and then switches into a maintenance mode to keep it there. The microprocessor manages an enhanced maintenance mode with two unique benefits. Once it detects a full charge it goes into a full rest cycle, letting your battery cool down (not the typical float mode you find with cheaper units), eliminating the chance of losing electrolytes. After the rest cycle it puts a load on the battery for a partial drain to exercise the battery and then recharges it. The unit features reverse polarity protection to prevent shorting the battery, the charger, or even an explosion if the wires accidentally get crossed. A selectable charging rate of 20A/10A/2A can quickly recharge even a large dead battery. For use on any 6- or 12-volt lead-acid car, boat, or power equipment battery you might have, including Conventional, Maintenance Free, AGM, Gel Cell, Spiral Wound, Deep Cycle, and Marine.
- For use on 6- or 12-volt lead-acid batteries
- 9" long x 8" wide x 4 1/4" tall
- 6' power cord length (outlet to charger)
- 6' cord length from charger to alligator clamps
- Fully automatic operation, advanced multi-phase charging process
- 20A/10A/2A charge rates
- Reverse polarity protection
- Battery fault detection
Read/download information on using the Battery Charger/Maintainer (Adobe PDF format).